User's Guide

Unifly Operator App User Guide Rel. 2.3
Page 2 of 27
2 BLIP Product
BLIP Hardware and Software
Figure 1 The BLIP
The BLIP is packaged in a weatherproof sealed enclosure.
The Bluetooth MAC address is used to identify and connect the Unifly Operator app to the BLIP.
It is encoded in the QR code printed on the front side of the enclosure and is also printed on the top label on the back
side. The bottom label contains the certification symbols and the hardware revision number i.e. R2.3.
The free Unifly Operator app communicates with the BLIP over Bluetooth and can be used to:
• Configure the BLIP
• Control the flight status
• Readout and monitor the remote identification parameters
• Upgrade the BLIP firmware
• Show the flight path as reported by the BLIP
The tracking data is sent by the BLIP over the LTE 4G mobile network to the Unifly Data Collector service which makes
the collected data available for further processing by other applications. In this way, the Unifly Monitoring system
uses the collected BLIP data for real-time visualisation of a drone’s location.