Installation Guide

5 4
INSTALLATION INSTRUCTIONS
DETERMINING IF THE RISER BAR
IS NEEDED
• You may or may not need to install the
riser bar, depending on the height of
yourreplace.
• To determine if you need the riser bar,
place the glass door unit in front of
yourreplacetoseeifittsyour
replaceopening.
• If the top of the glass door unit does not
reachthetopofyourreplaceopening,
you can install the Riser Bar to the bottom
of the unit to add extra height to the unit.
1
Riser Bar
M
O
1. RISER BAR INSTALLATION
To attach the riser bar:
•Laytheunitfacedownonasoftatsurface.
• Attach the Riser Bar (M) to the bottom
of the unit by inserting the Long Machine
Screws (G) through the holes in the Riser
Bar and the holes on the bottom of the
unit, as shown.
• Secure the Long Machine Screws using
the Hex Nuts (H), as shown.
Hardware Used
Long Machine Screws (x2)
Hex Nuts (x2)
G
H
H
G
M