User's Guide

April 4, 2019
USER GUIDE: UBS-200L LF DESKTOP READER
21
Chapter 3 – Operating and Configuring the UBS-200L | Unified Information Devices
001.006.03 v1.3
Caution:
Some Module parameter values are factory set, and changing
them may result in undesired behavior.
Symptom
Possible Cause
Remedy
Transponder Communications
Unit returns “#10”
during attempted
transponder
communications
Antenna is
improperly
connected.
Ensure antenna is properly
connected. See Connecting an
External LF Antenna.
Antenna positioned
too close to metal.
Re-position antenna away from
metal. See Metal vs. Non-Metal.
Unit returns
“XXXXXXXX” while
searching for a
transponder
Transponder too far
away
Move transponder closer to
antenna.
Transponder
incorrectly oriented
Ensure transponder is properly
oriented relative to antenna. See
Transponder Orientation.
Transponder
communications
blocked by metal.
Minimize interference by metal.
See Metal vs. Non-Metal.
Cannot read data
blocks
Incorrect data block
read attempted.
Ensure correct data block is
requested. See Reading
Transponder Data “RD”.
Incorrect
transponder type.
Data password
protected.
Ensure transponder is UI Devices
type.
Cannot write data
blocks
Incorrect data block
write attempted.
Ensure correct data block is
requested. See Writing
Transponder Data “WD”.
Incorrect
transponder type.
Data password
protected.
Ensure transponder is UI Devices
type.
Transponder too far
away
Move transponder closer to
antenna.
Transponder
incorrectly oriented
Ensure transponder is properly
oriented relative to antenna. See
Transponder Orientation.
Transponder
communications
blocked by metal.
Minimize interference by metal.
See Metal vs. Non-Metal.