User's Guide

April 4, 2019
USER GUIDE: UBS-200L LF DESKTOP READER
11
Chapter 2 Getting Started with the UBS-200L | Unified Information Devices 001.006.03
v1.3
Reading a Transponder in “Continuous Read” Mode
Present a transponder to the UBS-200L antenna. The transponder ID and any pre-programmed data
displayed on the LCD should also appear over the VCOM port.
Reading a Transponder in “Standby” Mode
1. Type “MD 2” to ensure the unit is operating in “standby” mode.
2. Type “GT” into the terminal window and press <ENTER>. If no transponder is present at the
reader antenna, “XXXXXXXX” may appear after a short delay, indicating that no transponder was
found.
Information:
If the “CN” parameter is set to 1, the “XXXXXXXX” indicator will be
suppressed, and NOTHING will be returned to the host. Proceed
to the next step to ensure proper functionality.
3. Now place a transponder on the reader antenna and type “GT” followed by <ENTER> again. If
the transponder is properly positioned above the reader antenna, the transponder ID will be
immediately displayed.
4. Congratulations! The reader is successfully reading the transponder!