User's Guide

April 4, 2019
USER GUIDE: UBS-200L LF DESKTOP READER
7
Chapter 2 – Getting Started with the UBS-200L | Unified Information Devices 001.006.03
v1.3
Chapter 4 – Tips and Tricks for Optimum Performance. The unit beeps once, and the transponder ID
appears on the LCD display.
Congratulations! A transponder has been read!
Information:
If the ID does not appear when a UI Devices transponder is
presented to the antenna, it is likely that the UBS-200L has been
pre-configured in “Standby” mode. Continue with “Connecting to
Host PC” to complete set-up and begin reading transponders.
Connecting to Host PC
Plug the “A” end of the USB cable into an available port on the host PC.
Figure 6. Plug cable into USB port of the host PC.
Plug the “B” end of the USB cable into the port labeled “USB” on the back of the UBS-200L.
Figure 7. Plug cable into USB port of UBS-200L.
Note:
If Keyboard Wedge functionality is required, and the UBS-200L
has been pre-configured to operate in Keyboard Wedge mode,
then plug the “B” end of the USB cable into the Keyboard Wedge
or “KW” port. Proceed to Reading a Transponder in “Keyboard
Wedge” Mode.