User's Guide

USER GUIDE: UBS-200L LF DESKTOP READER
April 4, 2019
Unified Information Devices | Chapter 2 – Getting Started with the UBS-200L
4
Connecting an External LF Antenna
Connect an external antenna or “wand” to antenna port 1 on the UBS-200L. If the UBS-200L has more
than one antenna port, port 1 is that closest to the edge of the unit.
1. Line up the pins of the antenna connector with those of the antenna port.
2. Rotate the entire antenna connector until it seats itself in the antenna port.
3. Gently tighten the outer ring to hold antenna cable securely in place.
Figure 4. Plug antenna connector into lower antenna port.
Caution:
The outer ring of the antenna connector should thread very easily.
If resistance is encountered, ensure connector is properly aligned
with antenna port. Do not force, as the threads may be damaged!
Powering the Unit
Power-up the UBS-200L by pressing the power button. The power LED will illuminate, indicating power
has been correctly applied.
Figure 5. Power switch – Power is applied.