User's Manual

ManualsBrandsUnifat Technology ManualsAudio EquipmentMini Speakerphone

C. Call Operations

Making / Receiving Calls

User can make a call either from the mobile phone or YD-

V44. Before you make or receive calls, ensure:

• Bluetooth

connection is established between your

BTS30 and mobile phone

• Battery is fully charged

1. Answering Calls

NOTE: Calls may be answered via the mobile handset

in the normal way.

To answer calls via the BTS30:

• Check if power is ON and device is linked

• The BTS30 will ring or emit a beep sound when

there is an incoming call

• Press the SEND/END button when ring tone is

heard

NOTE: Some ﬂip phones may require you to change

phone answer setting to any key answer.

2. Rejecting Calls

• The BTS30 will ring or emit a beep sound when

there is an incoming call

• Press and hold the SEND/END button for 2

seconds to reject a call

3. Terminating a Call

NOTE: Calls may be ended through the mobile phone

To end calls via the BTS30:

• Press the

SEND/END button

• Activate the Bluetooth

settings of your mobile phone

NOTE: The following steps are general procedure; to

access Bluetooth

Menu for your mobile phone, please

refer to your phone user manual.

• Select SET-UP or CONNECT from your mobile phone

• Find and select OPTION to discover Bluetooth

devices; establishing a connection may take several

minutes

• If found, phone display should indicate BTS30 device

was detected or Select “BTS30 ” from the list

• Phone should give you a prompt asking if you want to

pair the device

• Select OK or ACCEPT and wait for prompt to enter

passkey or PIN

• Enter the code 0000

• Select “OK” to pair and connect the BTS30 and the

handset

NOTE: The BTS30 can pair with more than one phone,

however it can only connect to one phone at a time. If

you wish to pair to a second phone, disable or turn OFF

Bluetooth

on the phone already paired.

NOTE: Under the pairing mode, if the BTS30 and mobile

handset did not successfully pair, follow the steps below

to retry pairing:

• Turn BTS30 OFF

• Turn OFF all other Bluetooth

devices before starting

the pairing process

• Repeat the pairing instructions from the beginning