Owner`s manual

9
If you are having trouble with a repeater or if you want to
replace one, you need to register the repeater to the base.
Connect the repeater close to the base for easy access to
the necessary buttons and indicators. Locate the repeater
in the desired position after registration is complete.
•
On the base, open the menu and select Register Accy. 1.
On the back of the repeater you want to register, press
and hold the registration button until the LINK light on the
front starts to blink (about 2 seconds).
2.
Release
the button and wait for the LINK light to turn on and
steady (this can take about 90 seconds). The repeater has
been registered to the base.
3.
If... Try...
the
LINK light
won't turn on
- checking the repeater's AC adapter
connecting the adapter to a dierent outlet.
the
LINK light
continues
ashing
- disconnecting the unit's AC adapter. Wait
about ten seconds, then try again.
- making sure there are not already 6 repeaters
registered to this base.
- making sure no other base or repeater is in
registration mode.
Only register one repeater at a time. If more than one
repeater is in registration mode at the same time then they
can interfere with each other.
♦
Only register a repeater to one base at a time. If more than
one base is in registration mode at the same time then you
can't control which base the repeater registers to.
♦
If you want to register two or more repeaters to this base,
just repeat these steps with the second repeater.
♦
Registering Repeaters to the Base