Owner`s manual

3
GETTING STARTED
Installing Your Phone
Charge the Battery
1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the notch
and slide the cover down and off.
Line up the battery connector with the jack inside the 2.
handset; the connector only fits one way.
Push the connector in until it clicks into place; tug 3.
gently on the wires to make sure the battery is securely connected.
Replace the battery cover and slide it into place.4.
Use an AC adapter to connect the power jack on the base to a regular 5.
indoor (240V AC) power outlet. Connect any chargers the same way.
Place a handset in the base with the display facing forward. If the 6.
display doesn’t light up, reseat the handset or connect the base to
a different outlet. For 2 or more handsets, place each handset in a
charger.
Charge all handsets completely (about 15 hours) before using.
#
Connect the Telephone Cord
Use the telephone cord to connect the
TEL LINE
jack on the base to a
standard telephone wall jack.
Test the Connection
Pick up the handset and press 1. Home/FlasH . The handset sounds a dial
tone, and the display shows Talk .
If you don't hear a dial tone or the display says –
Check Tel Line, check the
connection between the base and the phone jack.
Make a quick test call. (Press 2.
end to hang up.)
If there’s a lot of noise, check for interference (see page 25). –
Test all handsets the same way. If you can't get a dial tone, move the 3.
handset closer to the base.
Attaching the Belt Clip
Line up the holes on each side of the handset. Insert the belt clip into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the
tabs from the holes.
Elite9135om_20110115.indd 3 21/9/11 4:53:23 PM