Specifications
VS2100XR Operating Guide
®
Page 10
When you disarm the alarm, your car's interior lights can turn on for 30 seconds to help you find
your car at night and make sure no one is hiding inside. This is optional and requires an
additional relay.
INTERIOR LIGHT SUPERVISION
If your alarm was triggered when you were away, the siren will chirp four times and the indicator
lights flash four times when you disarm your alarm.
This memory is automatically cancelled when you turn the ignition switch ON.
TAMPER INDICATOR
Appendix 1 PROGRAMMABLE FEATURES
If your alarm was triggered when you were away, the LED will flash for 30 seconds after you
disarm the vehicle. The number of flashes can be used to determine the activated zone. Please
refer to Appendix 3 - page 11 for more details on this feature.
This memory is automatically reset when you turn the ignition switch ON.
TRIGGERED ZONE INDICATION
l Chirp control
— Chirp ON or Chirp OFF.
Your alarm can be programmed to
permanently disable the siren’s arm and
disarm chirps (except pre-intrusion).
Please refer to page 6 for more details.
The factory default is ON.
l Active / Passive arming
— In active arming, press Remote Control
button #1 to arm the alarm.
— In passive arming, the alarm arms itself
when you turn the ignition OFF and close
the last open door.
Please refer to page 4 for more details.
The factory default is ACTIVE.
l Auto re-arm and re-lock
— After disarming, the alarm will ;
• Automatically re-arm after 30 seconds
• Automatically re-lock after 30 seconds
(if connected with optional central locking)
Note : Auto re-arm and relock will be
cancelled if a door is opened within 30
seconds.
Please refer to page 6 for more details.
The factory default is ON.
l Current Sensing
— Current Sensing ON or OFF.
Current sensing provides a basic level of
protection by sensing when the interior
light comes on, or the engine is being
started. In most circumstances it is
recommended that current sensing be set
to OFF and that door, bonnet and boot
switches are used.
The factory default is OFF.
l Ignition-controlled door lock
— The doors can be set to automatically
lock when the ignition is turned ON and
unlock when the ignition is turned OFF.
Please refer to page 9 for more details.
The factory default is OFF.
l Automatic Engine Immobiliser (AEI)
—With this programmable feature set to
ON the engine will automatically be
disabled after 10 minutes, even if you
forget to arm the alarm!
Please refer to page 8 for more details.
The factory default is ON.
Programmable features allow you to customise your alarm.
The alarm comes with factory defaults, which are the recommended settings, as shown below.
Upon request, your Dealer can re-program them when the alarm is installed.