RF Remote Controlled Vehicle Security System Operating Guide

p~., " ""~,~_'<>.,...,.."""""",,,,~~~I;t~~~~~~- .
QUIET MODE
QuietModeallowsyouto usethetransmitterto temporarilyarmor disarmthe alarmwithout
chirps. BypressingButton#2 andthen,within10seconds,pressingbutton#1, thealarmwill
eitherarmor disarmwithoutchirpingforthatonetimeonly. Whenyouarrivehomeatnight
andwantto armyouralarmwithoutdisturbingyourneighbor,QuietModeletsyouarmyourcar
withouttheawakeningsirenchirps.
2nd CHANNEL OUTPUT (optional)
Pressingbutton#2 ofyourtransmitterfor3 secondstriggersthesecondchanneloutputfrom
youralarm. Thisoutputcanbe usedto operateoptionalaccessoriessuchasautomaticboot
release,etc. Thisoutputisoperablewhentheignitionkeyis OFF. Therefore,accidentally
pressingthe 2ndbuttonwillnot opentheboot.
TROUBLE SHOOTING
Your VS2000XR is an extremely reliable vehicle security system. In most cases, the
rare operational difficulties are the result of a weak transmitter battery or an open car
door. Below are guidelines for solving the majority of the problems you may
experience. If after following these guidelines you have not found the problem,
contact your professional installer immediately. .
1. No siren sound or chirp when transmitter button is pressed for arming or disarming:
a. Checkif theRedwirehaspower,whiletheBlackwireisproperlygrounded.
b. Replacethe transmitterbatteryandcheckthe clipsfor properpolarity.
c. Checkthatalldoorsareclosed. .
2. Transmitterworksin someareasandnotin otherareas:
Thisis probablyduetoexcessRFactivityinthatarea(usuallyjustashorttimeandonlywhileyou
areinthatarea,dependingonthetypeoftheactivity).It isonlytemporaryand.won'taffectthealarm
in otherareas. :
3. Alarm sounds for no apparent reason:
Be surethatthe transmitterbuttonis notbeinghelddowntoolong,or somethingin yourpocketor
purseis notpressingagainstthetransmitterbutton: Thereceivermayalsobe pickingup
interferencefroma nearbyairportor militarybase,Iow-flyingplaneor othersources. Such
interferenceistemporary. '
4. Alarm does not arm manually or automatically but the doors will lock/unlock when the
transmitter is pressed. Whenignition is off, LED has a long flash (1.5 sec. on, 0.5 sec. off).
When ignition is on, LED is off.
A. Thealarmwasaccidentallyswitchedtovaletmode.
S. Turntheignitionon,presstheV.E.T.switchonce,thentumtheignitionoff. Alarmcannowbearmed.
NOTE1: If thealarmstilldoesnotfunctionproperlyaftercheckingtheV.E.T.switch,consultthe UNIDEN
dealerwhereyoupurchasedtheproductforfurtheradvise.
NOTE2: Undernocircumstancesshouldyou makeany repairsoradjustmentstoanycomponentof the
transmitterorreceiver. Unauthorizedrepairsoradjustmentsto anycomponentswill voidthe
warranty.However,youmaychangethetransmitterbatterybyyourself,if needed,as shown
below.
CHANGING THETRANSMITTER BATTERY
1. Unscrew the small screw from the transmitter's back.
2. Replace the battery. MAKE SURE THE POSITIVE AND
NEGATIVE BATTERY ENDS CORRESPOND
CORRECTLY TO THE POSITIVE AND NEGATIVE
BATTERY CLIPS. ,
3. Place back the front cover, taking care not to break the LED.
4. Place back the screw, turning it in tight enough to hold the case
together, but not so tight that the case cra,cks..
BATTERYCliPS
SEA177
-~-
~r
j I
----------
--
--