Owner`s manual

Set Unlock Time

Press and hold the Accept button and Unlock button, on the Receiver, at

the same time for 5 seconds in the standby mode, then the LCD display

will show the time that has already been set.

1. Press and hold the Unlock button and the Accept button at the same

time for 5 seconds in the standby mode, then the LCD display will show

‘Unlock Time’.

2. Press the left or right navigation buttons to select the respective

Camera.

3. Press the Up and Down navigation keys to select the unlock time (1-25

seconds).

4. Press the Camera button to save the settings. The display will show

Save OK.

Connect the Camera to an optional DC Power/Door-Lock Module to

enable an electronic unlock system. You can set the unlock time (i.e., time

limit set to unlock the door once the unlock key has been pressed), by

following the steps below.