Owner`s manual

11
Power On/O
To power on/off the Receiver, press and hold the Power button.
Registration
1. Press the Call button on the Camera.
2. Then press and hold the Register button on the Camera, until the LED
starts flashing.
3. Next, press MENU on the Receiver and select the option Register.
4. Press MENU again to confirm the selection. A tone will be heard
confirming that the registration has been successful.
OPERATIONS
If the tone is heard twice then the Registration has been unsuccessful.
Before you try again, switch off the Receiver and remove the batteries
from the Camera.
Turn on the Receiver, reinstall the batteries of the Camera and try
registering again.
# The Receiver can support up to 4 Cameras.
Call button
Register button
The UWG400 comes with the Camera registered to the Receiver. If you
want to register another Camera to the Receiver, follow the steps below.