Specifications

file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/ProgrammingLocations.html
Programming locations
To use Location-based Scanning with a particular system, you will need to program your scanner
with the geographic coordinates you want to use for each site or channel group. You can also
program your scanner to alert you when you approach particular locations.
● Programming a location for a site
● Programming a location for a channel group
● Programming general locations
❍ To create a new location
❍ For Dangerous Xing and Dangerous Roads only
❍ Edit an existing location
Programming a location for a site
Each system site can have separate location information.
1. Open the Program System menu.
2. Select the system you want to program for location based scanning.
3. Select Edit Site, then select the first site you want to assign a location to.
4. Select the Set LocationInfo menu and enter the latitude, longitude, and range for this site.
5. Change the Set GPS Enable field to On .
6. Go back to the Edit Site menu and repeat these steps with any other sites you want to
program for this system.
Programming a location for a channel group
Each channel group in a system can have separate location information.
1. Open the Program System menu.
2. Select the system you want to program for location based scanning.
3. Select Edit Group, then select the first channel group you want to assign a location to.
4. Select the Set LocationInfo menu and enter the latitude, longitude, and range for this site.
5. Change the Set GPS Enable field to On .
6. Go back to the Edit Group menu and repeat these steps with any other sites you want to
program for this system.
Remember: You have to turn on Set GPS Enable before the location information
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/ProgrammingLocations.html (1 of 3)4/7/2009 10:08:59 AM