Owner`s manual

89
Searching and Storing
Another approach is
F + [SCAN/SEARCH] 
Quick Search? Yes=”E” / No=”.”
Press [.No] then
 to Edit Custom F
At this point you can edit each of the settings that comprise a custom search.
Edit Name — lets you edit the custom search range’s name.
Edit Srch Limit — lets you view and select the frequency ranges to search.
The scanner prompts you to enter the upper and lower search limits.
Set Delay Time — lets you set the amount of time the scanner will delay before
continuing to search after a transmission ends.
Set Modulation — lets you set the custom search range’s modulation type.
Set Attenuator — lets you set whether the scanner will attenuate reception by
20 dB during search.
Set Data Skip — lets you set whether the scanner will skip data transmissions
during search.
Set Step — lets you set the custom search range’s step (the gap between
frequencies).
Set C-Ch Only — lets you search for a Motorola control channel. If it finds one,
the scanner scans the system.
Set Record — if during your listening to the selected service, if a transmission is
received, choosing On will send an audio signal to the connected audio recording
device.
Search with Scan — sets whether the scanner includes the custom search
during scanning. If unlocked, the scanner first scans all selected systems, then
searches the selected service searches for the selected hold time (0-255
seconds).
Within this menu item are the following settable options
Set Quick Key — lets you assign a Quick Key for the custom search range.
Set Startup Key — lets you decide which custom search range should be
unlocked and scanned at power up
UB356ZH.fm Page 89 Wednesday, December 19, 2007 11:28 AM