Owner`s manual

65
Programming Your Scanner
[MENU]
 Program System F
 Select a conventional system F
 Edit Sys Option F
 Set Startup Key F
Select a startup key from 0-9 or select [.No] for no startup key.
Notes:
• To unlock the system at startup, press and hold the selected startup key while
you apply power. If you do not press the startup key at the time you turn on
power, you can still act while the opening screens are displayed.
• The system Quick Key is also enabled.
• If you press a different key at startup, the system is locked out.
• If you do not assign the system a startup key, the system is not affected by any
key press during startup.
[MENU]
 Program System F
 Select a conventional system F
 Edit Sys Option F
 Set Lockout F
Unlocked — The system is scanned when its quick key is enabled.
Temporary L/O — The system is not scanned, even if its quick key is enabled.
Cycling power removes the lockout.
Lockout — The system is not scanned, even if its quick key is enabled. You must
manually unlock the system.
[MENU]
 Program System F
 Select a conventional system F
 Edit Sys Option  F
 Set Hold Time  F
Set how long the scanner will remain scanning on this system before moving to the
next system (up to 255 seconds). Note that the scanner will scan all unlocked
channels at least one time, regardless of the system hold time setting.
Setting the Startup Key C
Setting the System Lockout C
Setting the System Hold Time C
UB356ZH.fm Page 65 Wednesday, December 19, 2007 11:28 AM