User manual

ARC250 User Manual 1.10 - 41
6.5 Software settings: Virtual Control
Always start with VC: after starting the software, virtual is automatically
loaded.
VC always on top: Puts the VC window on top.
Store VC position: stores and remembers the virtual control window position.
Do not close editor: while running VC you can still access the memory editor.
IMPORTANT: while Virtual Control is active you can not use other options in the
software that communicate with the scanner, only one window can have access
to the serial communications port.
Show Status Window: when VC is minimized a status window is shown. The
default position is the right bottom corner of your screen.
You can change this position:
Open VFO.ini with notepad. Locate the [statuswindow] section.
You can change the left and top parameters to set position of status window.
When custom settings are used the custom parameter must be set to 1:
left=1
top=1
custom=1
will show status window in left top corner of your screen.