User manual

ARC250 User Manual 1.10 - 38
6.2 Software settings: Bandplan
Your scanner has a build in bandplan. This means that when you enter a
frequency, the scanner will automatically select mode and step from a
predefined list. For your convenience, ARC250 also knows this bandplan.
You can also modify the bandplan that is used by the software (see section 8).
IMPORTANT: you cannot modify the bandplan that is stored in your scanner.
Setup bandplan option: select SETUP _ SOFTWARE OPTIONS and then select
the BANDPLAN TAB:
Bandplan option:
- NONE > do not use the bandplan option
- BC250/785 Bandplan > use the predefined bandplan
- Custom bandplan > use the custom bandplan
Round option:
Like the scanner, ARC250 can round of frequencies. If you enter a frequency
the software looks up the step in the bandplan list, and then uses that
information to round of the frequency.
Bandplan check before upload:
When this option is selected the software will check the mode/step settings
before every data upload and correct if necessary.