User manual

ARC250 User Manual 1.10 - 28
3.2 MOTOROLA TYPE1:
For a TYPE 1 system it is very important that the trunk system is setup
correctly before any trunk id’s are uploaded to your scanner. Depending on the
fleetmap settings the scanner may not accept some trunk id’s.
BC250/296D: ARC250 will always use a custom fleetmap even if you selected a
predefined fleetmap. The correct settings for the custom plan are automatically
programmed. So a predefined fleetmap will be programmed as a custom
fleetmap due to limitations in the remote controls for BC250/296D. The
software automatically fills in the size codes.
Some size codes require more then one block. If you enter size code 12 in
block 0 the software will automatically set block 1 to size 12.
You can only program size 12 id’s in block 0,2,4 and 6.
Size Code Required blocks Blocks
12 2 0,2,4,6
13 4 0,4
14 8 0
For information about fleetmap programming refer to the scanner manual. For
a type 1 the fleetmap must be correct else the wrong trunk id’s are shown.