Specifications

PK-232 OPERATING MANUAL COMMAND SUMMARY
RESTART Immediate Command
Mode: Command Host: RT
RESTART is an immediate command that reinitializes the PK-232 while retaining the
user's settings. The effect of the RESTART command is the same as turning the
PK-232 OFF, then ON again.
RESTART does not reset the values in bbRAM. See the RESET command.
REtry “n” Default: 10
Mode: Packet Host: RY
Parameters:
“n” 0 to 15 specifies the maximum number of packet-retries.
The AX.25 protocol uses the retransmission of frames that have not been
acknowledged as a means to insure that ALL transmitted frames are received. The
number of retries that the PK-232 will attempt is set by the RETRY command
(default 10). If the number of retries is exceeded, the packet link may be lost.
RFec ON/OFF Default: ON
Mode: AMTOR Host: RF
Parameters:
ON -Mode B (FEC) signals are displayed in AMTOR Standby (default).
OFF -Mode B (FEC) signals are not displayed in AMTOR Standby.
Turn the RFEC command OFF to prevent the reception and display of all FEC signals
received while in AMTOR Standby.
2/93 A-68
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library