Specifications

_______________________________________________________________________________
RAWhdlc ON|OFF Default: OFF
Mode: Packet Host: RW
_________________________________ Parameters: _________________________________
ON - The PK-232 operates in a raw HDLC packet mode when HOST is ON.
OFF - The PK-232 operates in standard AX.25.
_______________________________________________________________________________
The RAWHDLC command enables the PK-232 to bypass the AX.25 packet implementation
and communicate directly with the hardware HDLC (Z8530).
HOST mode must be ON to communicate with the PK-232 in the RAW HDLC mode.
See Timewave's PK-232 Technical Manual for full information on Raw HDLC Mode.
_______________________________________________________________________________
RBaud "n" Default: 45 bauds (60 WPM)
Mode: Baudot RTTY Host: RB
_________________________________ Parameters: _________________________________
"n" - Specifies the Baudot data rate in bauds from the PK-232 to the radio.
_______________________________________________________________________________
RBAUD sets the radio ("on-air") baud rate only in the Baudot operating mode.
This value has no relationship to your computer or terminal program's baud rate.
Available Baudot data rates include 45, 50, 57, 75, 100, 110, 150, 200 and 300
bauds (60, 66, 75, 100, 132, 145, 198, 264 and 396 WPM).
You may use RBAUD UP (RB U) to go to the next highest Baudot speed or RBAUD
DOWN (RB D) to go to the next lowest Baudot speed.
_______________________________________________________________________________
Rcve Immediate Command
Mode: Baudot/ASCII/AMTOR/FAX/Morse Host: RC
_______________________________________________________________________________
RCVE is an immediate command, used in Morse, Baudot, ASCII, ARQ, FEC and FAX
modes to switch your PK-232 from transmit to receive.
o You must return to the Command Mode to use the RCVE command.
_______________________________________________________________________________
RECeive "n" Default: $04 <CTRL-D>
Mode: Baudot/ASCII/Morse/AMTOR/FAX Host: RE
_________________________________ Parameters: _________________________________
"n" - 0 to $7F (0 to 127 decimal) specifies an ASCII character code.
_______________________________________________________________________________
Parameter "n" is the numeric ASCII code for the character you'll use when you
want the PK-232 to return to receive.
The RECEIVE command allows you to insert a character (default <CTRL-D>) in your
typed text that will cause the PK-232 to return to receive after all the text
has been transmitted.
4/91 A-66
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library