Specifications

______________________________________________________________________________
NOmode ON|OFF Default: OFF
Mode: All Host: NO
_________________________________ Parameters: _________________________________
ON - The PK-232 switches modes only upon explicit command.
OFF - The PK-232 changes modes according to NEWMODE.
_______________________________________________________________________________
When NOMODE is OFF (default), your PK-232 switches modes automatically according
to NEWMODE. When NOMODE is ON your PK-232 never switches from Converse or
Transparent Mode to Command Mode (or vice versa) by itself. Only specific
commands (CONVERSE, TRANS, or <CTRL-C>) typed by you change the operating mode.
______________________________________________________________________________
NUCr ON|OFF Default: OFF
Mode: All Host: NR
_________________________________ Parameters: _________________________________
ON - <NULL> characters ARE sent to the terminal following <CR> characters.
OFF - <NULL> characters ARE NOT sent to the terminal following <CR>s.
_______________________________________________________________________________
The NULLS command sets the number of <NULL> characters that will be sent.
Some older printer-terminals require extra time for the printing head to do a
carriage return and line feed. NUCR ON solves this problem by making your
PK-232 send <NULL> characters (ASCII code $00) to your computer or terminal.
_______________________________________________________________________________
NULf ON|OFF Default: OFF
Mode: All Host: NF
_________________________________ Parameters: _________________________________
ON - <NULL> characters are sent to the terminal following <LF> characters.
OFF - <NULL> characters are not sent to the terminal following <LF>s.
_______________________________________________________________________________
Some older printer-terminals require extra time for the printing head to do a
carriage return and line feed. NULF ON solves this problem my making your
PK-232 send <NULL> characters (ASCII code $00) to your computer or terminal. The
NULLS command sets the number of <NULL> characters that will be sent.
_______________________________________________________________________________
NULLs "n" Default: 0 (zero)
Mode: All Host: NU
_________________________________ Parameters: _________________________________
"n" - 0 to 30 specifies the number of <NULL> characters to be sent to your
computer or terminal after <CR> or <LF> when NUCR or NULF are set ON.
_______________________________________________________________________________
NULLS specifies the number of <NULL> characters (ASCII $00) to be sent to the
terminal after a <CR> or <LF> is sent. NUCR and/or NULF must be set to indicate
whether nulls are to be sent after <CR>, <LF> or both. The null characters are
sent from your PK-232 to your computer only in Converse and Command Modes.
4/91 A-60
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library