Specifications

PK-232 OPERATING MANUAL COMMAND SUMMARY
MYMail call[-“n”] Default: none
Mode: Packet/MailDrop Host: Me
Parameters:
Call - The Call Sign you wish to use for the MailDrop.
“n” - Numeral indicating an optional substation ID (SSID) or extension.
Call is the call sign of the MailDrop, default -none.
“Call” may have an optional SSID, and must not be the same call sign and SSID as
MYCALL. If you do not set MYMAIL, the MailDrop will use the same call sign and
SSID as entered in MYCALL. For example, if you have set MYCALL to N7ML then
MYMAIL may be N7ML-1 through N7ML-15. You can use the CTEXT and MTEXT messages
to inform other stations who connect of your MYCALL and MYMAIL call signs.
MYPTcall callsign Default PK232
Mode: Pactor Host: Mf
Use the MYPTCALL command to load your call sign Into your PK-232.
If you have not loaded a call into the PK-232 with MYPTCALL, the call loaded in
MYCALL will be used. The difference between MYCALL and MYPTCALL is that MYCALL
allows only the dash (-) to be used while MYPTCALL will allow any punctuation
with the call.
If calls have not been loaded into either MYCALL or MYPTCALL, the PK-232 will not
allow transmission on Pactor. An error message “Need MYCALL" will be displayed
if transmission is attempted.
Example:
MYPTCALL K6RFK/ZL <Enter>
2/93 A-58
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library