Specifications

_______________________________________________________________________________
MWeight "n" Default: 10
Mode: All except Packet Host: Mw
_________________________________ Parameters: _________________________________
"n" - 5 to 15, specifies roughly 10 times the ratio of one dot length to one
inter-element space length in transmitted Morse code.
_______________________________________________________________________________
A value of 10 results in a 1:1 dot-space ratio. A setting of 5 results in a
0.5:1 ratio, while a setting of 15 (maximum) results in a 1.5:1 ratio.
MWEIGHT applies only to the Morse transmit mode and the CW ID in all modes
except packet. MWEIGHT does not affect the code output by the MID command.
_______________________________________________________________________________
MXmit ON|OFF Default: OFF
Mode: Packet Host: Mx
_________________________________ Parameters: _________________________________
ON - Monitor transmitted packets in the same manner as received packets.
OFF - Do not monitor transmitted packets.
_______________________________________________________________________________
When MXMIT is ON, transmitted packets are monitored in the same manner as
received packets. The monitoring of transmitted packets is subject to the
settings of MONITOR, MCON, MFROM, MTO, MRPT and TRACE. Most transmitted packets
occur during connections so MCON should probably be set to a non-zero value.
_______________________________________________________________________________
MYAlias call[-n] Default: none
Mode: Packet Host: MA
_________________________________ Parameters: _________________________________
call - Alternate packet digipeater identity of your PK-232
"n" - 0 to 15, an optional substation ID (SSID)
_______________________________________________________________________________
MYALIAS specifies an alternate call sign (in addition to the call sign specified
in MYCALL) for use as a digipeater only. In some areas wide-coverage digipeater
operators change their call sign to a shorter and easier to remember identifier.
_______________________________________________________________________________
MYALTcal aaaa Default: none
Mode: AMTOR Host: MK
_________________________________ Parameters: _________________________________
aaaa - Your alternate SELective CALling code (SELCALL)
_______________________________________________________________________________
Use the MYALTCAL command to specify an your alternate SELCALL which, under
certain conditions, may be convenient or necessary. You can enter an additional
SELCALL code not related to your call sign. The alternate SELCALL can be any
four alphabetical characters, or can be numeric strings of either four or five
numbers. MYALTCAL is generally used for special applications such as receiving
network or group broadcasts in AMTOR Mode B Selective (Bs or SELFEC).
8/91 A-56
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library