Specifications

_______________________________________________________________________________
MDPrompt text Default: (see text)
Mode: Packet/MailDrop Host: Mp
_________________________________ Parameters: _________________________________
text - Any combination of characters and spaces up to a maximum of 80 bytes.
_______________________________________________________________________________
MDPROMPT is the command line sent to a calling station by your MailDrop in
response to a Send message command. The default text is:
"Subject:/Enter message, ^Z (CTRL-Z) or /EX to end"
Text before the first slash is sent to the user as the subject prompt; text
after the slash is sent as the message text prompt. If there is no slash in the
text, the subject prompt is "Subject:" and the text prompt is from MDPROMPT.
_______________________________________________________________________________
MEmory "n" Default: none
Mode: All Host: MM
_________________________________ Parameters: _________________________________
"n" - A hexadecimal value used to access the PK-232's memory locations, or
read values stored at a specified ADDRESS.
_______________________________________________________________________________
The MEMORY command works with the ADDRESS command (ADDRESS $aabb) and permits
access to memory locations. Use the Memory command without arguments to read a
memory, and with one argument $0 to $FF to write to a memory location. The
value in ADDRESS is incremented after using the MEMORY command.
_______________________________________________________________________________
MFIlter n1[,n2[,n3[,n4]]] Default: $80
Mode: Morse, Baudot ASCII, AMTOR and Packet Host: MI
_________________________________ Parameters: _________________________________
"n" - 0 to $80 (0 to 128 decimal) specifies an ASCII character code.
Up to four characters may be specified separated by commas.
_______________________________________________________________________________
Use MFILTER to select up to 4 characters to be "filtered," or excluded from
Morse, Baudot, ASCII, AMTOR and monitored packets. Parameters "n1," - "n4" are
the ASCII codes for the characters you want to filter. The special value of $80
(default) filters all characters above $7F and all control-characters except
carriage-return ($0D), linefeed ($0A), and TAB ($09).
_______________________________________________________________________________
MFrom ALL/NONE or YES/NO call1[,call2..] Default: ALL
Mode: Packet Host: MF
_________________________________ Parameters: _________________________________
call - ALL/NONE or YES_list/NO_list (list of up to eight call signs,
separated by commas).
_______________________________________________________________________________
8/91 A-51
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library