Specifications

PK-232 OPERATING MANUAL COMMAND SUMMARY
APPENDIX A
COMMAND SUMMARY
A.1 Introduction
Your PK-232 is controlled by Commands that you enter from the keyboard.
Most of these commands have a standard (default) value that provides good
performance. There are a few commands that you will need to change. This
section is intended as a command and error message reference and is not
meant to be read from start to finish.
A.1.1 Entering Commands
Timewave Software for the PK-232 such as PC-PAKRATT has menus and even on-
line help for commands. If you are using a Timewave program, please
consult the Program manual for instructions on entering commands. The
instructions below assume you are using a terminal or terminal-emulating
program on your personal computer.
Most Commands are short names for the instruction you want the PK-232 to
perform. Commands are entered after the Command prompt "Cmd:".
• You may use either UPPER or lower case when entering commands.
• End the command with a carriage return <CR> or the <Enter> key.
• Correct any typing mistakes before typing the final <Enter>.
A.1.2 Command Responses
Whenever the PK-232 accepts a command it responds by displaying both the
old and new values. For example, if you type "XFLOW OFF" - you'll see the
display:
XFlow was ON
XFlow now OFF
This message tells you that the value has been changed successfully.
A.2 Command List
Commands are listed alphabetically in the following command
descriptions. Each command entry contains several sections:
Command Name, Default Value, Mode(s) in which the command is used,
HOST mode abbreviation (for HOST mode programmers), and Parameters
A.2.1 Command Names and Abbreviations
The command name at the beginning of the description is the full word
you can type in order to have your PK-232 execute this command. The
capital letters indicate the minimum abbreviation you can use instead
of the full word. For example:
You can enter the command MYCALL by simply typing "MY". (Note: DO NOT
type the "quotation marks") The abbreviation "M" is not sufficient,
but "MY”, “MYC”, "MYCA”, “MYCAL” or "MYCALL" are all acceptable.
4/91 A-1
From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library