Specifications

DAYSTAMP
ON DAYSTAMP
OFF
05-Nov-93 2l:42:27 KG6ZL
05-Nov-93
21 :42:24 KB6IUX*
21:42:27 KG6ZL
2l:42:24
KB6IUX*
Previously,
stations
heard
directly were displayed with an asterisk
(WlAWx)
and digipeated stations
were
shown without
(WZSZ).
Digipeating isn't
used as much as it used to be-most stations now use nodes, so
we've
stopped using the asterisk. However,
fbr those
few
cases in
which
a station is heard indirectly
through
a digipeater, that station's
call
sign is
displayed
with
the message,
"via
digi'l
In
addition,I- and U-frame
packets
with PIDs
of CF and CD are shown with the indicators
"N/R" (lbr
Net/
ROM) and
"IP"
respectively.
Clear the MHEARD
list with 7o, &, N,4(), NO/VE or
OFF.
Mld n
Mode:
packet
O
-
250 specifies
the Morse lD timing
in units
of l0-second increments.
0 Zero disables
this function.
If
"n"
is set
to a
value
between I and 250,
the
PK-96
will
periodically
issue a 20 WPM Morse ID. For ex-
ample, a MID of 177 would
cause a Morse ID to be
sent
every 1,770
seconds
(29.5
minutes). A Morse ID
will
be transmitted
only if a
packet
was sent since
the last Morse ID. The Morse ID uses TXDELAY,
PPERSIST,
and DCD.
If MID is
set to a
value
other than
0,
lD will force
a Morse ID immediatelv. If
both
HID and MID are active.
the Morse
ID will be sent first.
MID norrnally
sends aMorse ID
using on/off keying of the low
tone.If
FSK keying
of both tones is de-
sired
to
prevent
stations fiom
transmitting over
your
Morse ID,
see the UBIT
72
command.
Default: 0
(00
sec.)
Host:Mi
MMsg OI\AOFF
Mode: MailDrop
OFF The
MTEXT message isn't
sent at all.
ON The
stored MTEXT messase is
sent as the
is
established.
DefaLrlt:OFF
Host: MU
hrst response after a
packet
connect to
your
MailDrop
MMSG
enables or disables automatic
transmission of the MTEXT message when
your
MailDrop links
with
another
station.
Monitor
n
Mode:
packet
0 to
6
sets
different levels
of
monitoring
while the PK isn't connected.
Starting with 0, as you increase
the value
of
n
the more
"stuffl'
will be visible with
each
packet
you
inter-
cept:
0 You won't monitor
any
packets
while
you're
unconnected.
1
Only unnumbered
(UI)
frames resulting
from an unconnected transmission are displayed. Use this
lbr
an
"unproto,"
roundtable type conversation where
you
want
to
read
other
station's
packet
text-sent
unproto-while
you're
not
connected. This setting also displays beacons.
Default:4(UADMCDIUD
Host: MN