Instruction manual

Instruction Manual
BOOSTER KITS
Phone: [phone]
Email: [e-mail]
www.cellularbooster.com
Canadian Head Office
5005 Jean-Talon Street West #10
Montreal, Quebec, Canada H4P1W7
8
The Uniden trademark is owned by Uniden America Corporation and its affiliates is used under license by Signifi Mobile.
This guide will help you properly install your cellular booster kit. It is important to read through all of the
installation steps before installing your equipment. Thoroughly read through the instructions, visualize where
all the equipment will need to be installed and do a soft installation before mounting any equipment. If you
do not understand the instructions in full, please contact technical support at: 1-888-744-9797.
OVERVIEW
IMPORTANT: The signal (outdoor) antenna should always be separated from the
distribution (indoor) antenna by at least 20 vertical feet or 50 horizontal feet including
the separation of a thick barrier such as a roof or a wall.
Depending on the strength of your outdoor signal, the weaker the signal the less
separation distance is required.
BOOSTER – SELECT LOCATION
Install the booster in an area that is protected from the weather, properly ventilated and is
away from excessive heat and moisture.
1
SIGNAL (OUTDOOR) ANTENNA - SELECT LOCATION
Mount the signal (outdoor) antenna in an elevated outdoor location so that it points towards
the cellular tower and away from where the inside antenna will be located.
2
INDOOR COAXIAL CABLE - (IF USED)
The indoor coaxial cable is used to connect the distribution (indoor antenna) to the booster.
4
DISTRIBUTION (INDOOR) ANTENNA
The ideal location for the indoor antenna will be the area of your property where you need
to improve the signal most.
NOTE: The signal strength will be strongest closest to the antenna.
5
OUTDOOR COAXIAL CABLE - SELECT LOCATION
The outdoor coaxial cable is used to connect the signal (outdoor antenna) to the booster.
3