Instruction manual

Instruction Manual
BOOSTER KITS
Phone: [phone]
Email: [e-mail]
www.cellularbooster.com
Canadian Head Office
5005 Jean-Talon Street West #10
Montreal, Quebec, Canada H4P1W7
18
The Uniden trademark is owned by Uniden America Corporation and its affiliates is used under license by Signifi Mobile.
CHECK THE CELLULAR BOOSTER LED ALARM LIGHTS
Your cellular booster comes equipped with electronic sensors designed to identify cellular signal overload
or oscillation which can hinder signal-boosting performance. Your cellular booster is specially designed
to automatically decrease gain to compensate for these circumstances, the device also has a feature to
automatically shut down in case of excessive oscillation. Improper equipment installation and unusable
signal quality can cause oscillation, this is why it is important to fully understand the LED alarm lights on your
booster, as they will help you identify and solve any potential issues.
The color of the LED indicates the status of the booster system.
TWO TYPES OF LED INDICATORS
1. POWER indicator: Shows whether the cellular booster is on or off.
2. Signal indicators: The color of the LED indicates the status of the booster for each of these frequencies.
There is one alarm LED light for each of the cellular frequency ranges (850 MHz & 1900 MHz).
CHECKING THE SIGNAL STATUS
The signal indicator’s LED will notify you as to whether your cellular booster is experiencing any oscillation
or feedback. The purpose of these LED’s is to allow you to ne tune your booster to achieve optimal signal
quality.
The bullet list below indicates what measure should be taken based on the color of the LED alarm lights.
GREEN: indicates the system is working properly.
ORANGE: the system is experiencing slight oscillation and does require slight adjustment. See next page
for adjustment procedures.
RED: the system is experiencing severe oscillation and may be causing interference with the cellular
provider’s network. Turn the unit off and make adjustments as outlined next page.
OFF: if the LED is off it is likely the system went into oscillation so severe that the auto gain and level
control circuits turned the cellular booster off .