Instruction manual

Instruction Manual
BOOSTER KITS
Phone: [phone]
Email: [e-mail]
www.cellularbooster.com
Canadian Head Office
5005 Jean-Talon Street West #10
Montreal, Quebec, Canada H4P1W7
17
The Uniden trademark is owned by Uniden America Corporation and its affiliates is used under license by Signifi Mobile.
INSTALL YOUR CELLULAR BOOSTER
Install the cellular booster in a location that is properly ventilated and not exposed to excessive heat, mois-
ture and/or direct sunlight. The optimal area would be on a wall located near a power outlet.
It should be mounted in an easily accessible area so it’s easy to perform general maintenance with the coaxial
cable connections, dip switch settings and power adaptor.
Make sure all cables and antennas are securely connected before commissioning the system.
POWER UP YOUR CELLULAR BOOSTER
Once all the below precautions have been taken, power on the cellular booster.
The LED indicator marked power should light up green.
IMPORTANT:
Verify that you have left at least 20 feet of vertical and/or 50 feet of horizontal separation space
between the indoor and outdoor antennas.
1
Never point the front of the yagi signal (outdoor) antenna towards the inside of the distribution
(indoor) antenna.
2
Verify that the supplied coaxial cables from both the signal (outdoor) antenna and the distribution
(indoor) antenna are properly connected to the cellular booster before powering it up.
3
Carefully plug in the supplied 110-volt power adaptor into the back of the cellular booster where it
is marked ‘power’ and connect the other end to a power outlet.
4
WARNING! Using a power supply that is not included in your kit could damage your
equipment and void your warranty.