User Manual

- 14 -
Volt
13.5
Laser
x X, K, Ka band signal
Volt
12.8
Ka
33.800 GHz
Signal strength indicator (1 - 5)
x User Limit Speed Alarm
x Vehicle Low Battery Voltage Warning, Vehicle Battery Saver Alarm
Low Battery
THREAT
The R3 detects up to 4 radar band signals (threats) at a single time. The strongest rader signal is designated as
the Priority signal, and its frequency displays on the OLED. The other signals (threats) are indicated in the left
side of the display. In the following example, 2 K band, 1 X band, and 1 Ka band frequencies are detected.
X K Ka
K 24.120 GHz
MUTE MEMORY
Use Mute Memory to mute known areas of false alarms (such as department store automatic doors). The R3
remembers where you muted the audio (GPS location) and the frequency you muted. It will automatically
mute when you travel to that location and the saved frequency is detected; however, if a different frequency is
detected, the R3 alerts to that different frequency.
When you press
MUTE/DIM or the MUTE button on the charger to mute audio for a specific location, Mute On
displays. While Mute On displays, press MUTE/DIM or the MUTE button on the charger again to save that GPS
location to memory. Mute Memory displays on the screen.
R3 stores up to 200 Mute Memory points.
To delete Mute Memory points, press
MUTE/DIM or the MUTE button on the charger while Mute Memory
displays. The R3 displays a delete confirmation message; press
MUTE/DIM or the MUTE button on the charger
again to confirm. You can also delete Mute Memory points from Menus/Delete All Mute?
AUTO MUTE
When the R3 detects a signal, it sounds an alarm at the current volume level. To make the alarm quieter, turn
Auto Mute on through the menus. This will reduce the volume to VOL level 1 after the first 3 seconds. Auto Mute
ends 10 seconds after the alarm ends unless:
x The same signal is detected within that 10 second period; then, Auto Mute stays on.
x A different band signal is detected during that 10 second period; then, Auto Mute turns off and then back on
at the current volume level.
Auto Mute does not apply to Laser Alert.
USER SPEED LIMIT
When you set a speed limit thorough the menus, the R3 sends an alarm tone if your speed exceeds that speed
limit setting. If that happens, the unit announces and displays over speed warnings.