User Manual

- 13 -
HOW DO I ...? TRY THIS...
Turn bands on and off Press
MENU and cycle through the menu options until the band you want to
turn off displays. Press
MENU again to change that band’s status.
Change Highway to City or City
2 and back
Press
MENU . The first menu selection is Highway (default). Press MENU to
cycle through Highway, City, and City 2. After you select an option, press and
hold
MENU to exit. See page 10 for detailed information.
Set a user mark Press
MARK to create a user mark when you are at a location where there is
normally some type of radar. The R3 announces “User mark logged.” The R3
will announce when you approach user marks.
The R3 can save up to 200 user marks.
Delete a user mark Press
MARK again at that location to delete the user mark.
The R3 does NOT ask for confirmation before deleting single user marks.
Delete ALL user marks Press and hold
MARK to delete all user marks.
The R3 DOES ask for confirmation before deleting all user marks. Press
MARK again to confirm.
Update the firmware and
database
Refer to www.unidensupport.com for details.
FEATURE DETAILS
USER MARKS (LASER AND RADAR SITES)
With the R3, you can mark geographical points where you commonly encounter radar transmissions, These can
be school zones, red-light cameras, and places where police frequently monitor traffic.
When you are at the location, press
MARK . The R3 announces “User mark logged.” Now, when you approach
these points, the R3 announces “User mark ahead.”
Press and hold
MARK at that location to delete that user mark.
The R3 registers up to 200 user marks.
HIGHWAY VS CITY MODE
Uniden’s R3 radar detector operates in three different frequency (X, K, and Ka band) sensitivity modes -
Highway, City, and City 2. Highway mode is the most sensitive, with maximum detection ranges while on the
highway or open road. City and City 2 are on the lower end of the detection scale for city driving. These two
modes reduce sensitivity so that false signals (such as from automatic door openers) are filtered out.
Under factory default conditions (X band = off on all bands, K and Ka bands = on), the band sensitivities are:
x Highway: X band off; K and Ka band full sensitivity.
x City: X band off and K band sensitivity reduced; Ka band full sensitivity.
x City 2: X band off. K band sensitivity reduced. Ka full sensitivity.
Turn X band on in the menus with K and Ka bands still on (default); the mode sensitivities are:
x Highway: X, K, and Ka band full sensitivity.
x City: X and K band sensitivity reduced; Ka band full sensitivity.
x City 2: X band off. K band sensitivity reduced. Ka band full sensitivity.
If a band is turned off through the menus, it is off in all modes; however, X band is always off in City 2 mode,
regardless of menu setting.
POP MODE
In POP mode, the R3 can detect short burst from radars that are too fast for many other detectors to catch. You
can turn POP mode on and off in the Menu system.
ALARM PRIORITIES
x GPS Connected / GPS Error / Speed Camera / Red Light Camera / User Mark Alarm/POI Limit Speed Alarm
x Laser signal