User Manual

- 20 -
HOW DO I ...? TRY THIS...
Turn bands on and off Press MENU and cycle through the menu options until
the band you want to turn off displays. Press MENU
again to change that band’s status.
Change Highway to City
or set attenuation levels
in Advanced mode and
back
Press MENU. The first menu selection is Highway
(default). Press MENU to cycle through Highway, City,
and Advanced. After you select Highway or City, press
and hold MENU to exit. If you select Advanced, press
+ to select either the K or Ka band to adjust. Press
MENU to adjust sensitivity levels in 10% increments.
Press + again to adjust the other mode.
Set a user mark Press MARK to create a user mark when you are at a
location where there is normally some type of radar.
The R3 announces “User mark logged.” The R3 will
announce when you approach user marks.
The R3 can save up to 500 user marks.
Delete a user mark Press MARK again at that location to delete the user
mark.
The R3 can save up to 500 user marks.
Delete ALL user marks Press and hold MARK to delete all user marksr.
The R3 does NOT ask for confirmation before deleting
single user marks.
Update the firmware and
database
Refer to www.unidensupport.com for details.
FEATURE DETAILS
AUTO DIM
The Auto Dim feature only displays in the menus if you select Auto using the R3 unit’s
MUTE/DIM button or the power cord’s MUTE button. Use this feature to set when
the OLED changes brightness levels and to what brightness levels it changes. For
example, you can set the R3 to shift to Bright level at 6:00 AM and then to Dimmer
level at 6:00 PM.
Set DIM to Auto from the R3/Power Cord
1. Press and hold the MUTE/DIM button on the R3 device or the MUTE button on
the power cord. The current DIM level displays on the OLED.