Specifications

Vancouver Police Service
Command
Production Specification
SVI #847 Page 81 of 107 September 18, 2012
TAIL LIGHTS
Rear body tail lights shall be vertically mounted per Federal Motor Vehicle Safety Standards. The following lights shall be
furnished:
• Two (2) Whelen 900 Series 90A00TAR amber LED turn signal lights
• Two (2) Whelen 900 Series 90R00XRR red LED stop/tail lights
• Two (2) Whelen 900 Series 90J000CR halogen back-up lights with clear lens
Each of the lights above shall be mounted in a 9EFLANGE, chrome finish bezel.
MIDSHIP MARKER/TURN SIGNAL
Two (2) Whelen LED midship body clearance marker/turn signal lights (T0A00MAR) shall be installed. There shall be one
(1) light on each side of the body, in the wheel well, ahead of the rear axle. Both lights shall have an amber lens and
operate with the chassis clearance marker and turn signals.
MARKER LIGHTS
The apparatus body shall be equipped with all necessary clearance lights and reflectors in accordance with Federal Motor
Vehicle Safety Standards (FMVSS) regulations. All body clearance lights shall be Truck-Lite Model 18 LED to reduce the
need for maintenance and lower the amp draw. Clearance lights shall be wired to the headlight circuit of the chassis.
CAB STEP LIGHTS / GROUND LIGHTS
There shall be two (2) OnScene Solutions 9" LED NightStik light(s) installed on the vehicle capable of providing
illumination at a minimum level of 2 fc (20 lx) on ground areas within 30 in. (800 mm) of the edge of the vehicle in areas
designed for personnel to climb onto or descend from the vehicle to the ground level.
Lighting designed to provide illumination on areas under the driver and crew riding area exits shall be switchable but
activated automatically when the exit doors are opened.
LICENSE PLATE LIGHT
One (1) Arrow #437 chrome plated LED license plate light shall be installed on the rear of the body. License plate light
shall be wired to the headlight circuit of chassis. A fastener system shall be provided for license plate installation.
ELECTRONIC SIREN
One (1) Tomar model 940N, 200 watt, remote control siren with microphone shall be provided in cab. The siren shall be
installed in cab within easy access of Driver.
SIREN SPEAKER
Two (2) Cast Products Inc. model SA4311, 100 watt siren speaker shall be provided recessed in the front bumper, one (1)
on the streetside and one (1) on the curbside.