Specifications

Vancouver Police Service
Command
Production Specification
SVI #847 Page 69 of 107 September 18, 2012
UNDER CABINET, RADIO MOUNTING CONSOLE
There shall be three (3) under cabinet mounted radio/communication console(s) provided in the interior. The radio cabinet
shall provide mounting area for the radios specified.
The radio cabinet shall be constructed of 1/8" smooth finish aluminum and painted with a hammer tone powder coat paint
finish for a hard durable surface. Paint color shall be gray or black. The front of the cabinet shall have standard bolt-on 8-
1/2" x 3" black radio trim mounting plates. A hinged 3/16" aluminum drop down access cover shall be provided on the
bottom to access equipment mounting and wiring with 1/4 turn knobs to secure cover closed. Two (2) 12 volt cooling fans
and 12 volt power and ground provisions shall be provided for proper installation and ventilation of radio equipment.
Each cabinet shall be a minimum of 4" high x 14" deep. The width of each cabinet shall be (insert actual dimensions) and
located under overhead cabinets.
INTERIOR UNDER CABINET LED LIGHTS
Three (3) OnScene Solution model #70152, 10” x 6” x 7/8”, 10-30 VDC, surface mount dual red and white LED light(s)
with clear lens shall be provided under cabinet. Each light shall be individually switched with a high/low intensity setting. In
addition light(s) will be capable of a five (5) second delay after switching off.
SLIDE-OUT AREA - FULL WIDTH DESK
The slide-out area shall be provided with a full width desk which shall be 24" deep and located approximately 30" from
floor. The front edge of the desk top shall be reinforced with 2" x 2" tubing in order to support a person sitting on the edge
of the desk.
The desk top surface shall be fabricated of 3/16" smooth finish aluminum. It shall have a 2" vertical downward edge along
front to cover the 2" x 2" reinforcement. There shall be 2-1/2" diameter holes with plastic edge grommet provided at each
rear corner for wiring of future equipment located on the desk top. The desk shall be painted with a dark gray hammer
tone powder coat paint finish for a hard and durable surface.
WALL MOUNTED CONNECTION PANEL
There shall be three (3) wall mounted connection panel(s) provided in the interior. Panel(s) shall be constructed of 1/8"
smooth finish aluminum and painted with a hammer tone powder coat paint finish for a hard durable surface. Paint color
shall be gray or black.
Unless otherwise noted, each panel shall contain the following items:
• There shall be one (1) USB outlet(s) and cable provided for position 1. The outlet shall be labeled and routed to the
specified Smartboard overlay system.
• There shall be three (3) phone connection(s) with wall plate provided in the front face of the connection panel.
• There shall be six (6) RJ45 data port(s) with shielded CAT6 cabling provided in the front face of the connection
panel(s). The cabling shall terminate at the equipment rack mount patch panel with 12" of slack per cable. A cable
certification report confirming that all network wiring complies with CAT6 specifications shall be included with the
completed apparatus.
• There shall be two (2) two-gang 12 VDC outlet(s) provided in the front face of the connection panel, one (1) in the
foreward position, one (1) in the rearmost position.
• There shall be three (3) 120 VAC, 20 amp, duplex straight-blade receptacle (NEMA 5-20R) outlet(s) provided in the
front face of the connection panel(s).