Specifications

Vancouver Police Service
Command
Production Specification
SVI #847 Page 36 of 107 September 18, 2012
EXTENDED CAB MODIFICATION
The extended cab area shall be modified to create an equipment storage area as follows;
• The rear cab window shall be removed and replaced with a painted panel that shall match the cab color. The painted
panel shall be mounted in the cab sheet metal frame with window rubber moulding.
• The side cab windows shall be removed and the sheetmetal of extended cab area directly below cab windows shall
be removed and a ROM Series III roll-up door shall be installed one (1) on each side of cab. Each door shall have a
keyed lock. Each door shall be painted to match the color of the as cab/chassis.
• Each door shall have a drip pan installed below the door roll. Each drip pan shall drain to an area below the floor of
the cab.
• Aluminum panels shall be bolted in place to divide the front crew area from the new equipment storage area. The
aluminum panels shall be painted with a hammer tone powder coat paint finish for a hard durable surface. The paint
color shall be gray.
• A total of eight sections of vertical aluminum shelf-trac shall be provided, four (4) on the front wall, and four on the rear
wall of cab for specified component installation.
• Two (2) adjustable shelves shall be provided, one (1) on each side for storage of Vancouver Police Department
equipment. Each shelf shall be fabricated from 3/16" 3003 aluminum sheet with a 2" vertical flange along the front and
rear edges.
MUD FLAPS
There shall be rubber mud flaps with anti-sail bars furnished and installed behind each set of tires.
AIR BRAKE SYSTEM QUICK BUILD-UP
There shall be one (1) Milton male quick connector type air shoreline inlet to provide air to the chassis air tanks from an
external source compressed air shoreline hookup in order to maintain full operating air pressure while the vehicle is not
running. Air inlet shall be located near driver's door. The female end of the connector shall be supplied by the Vancouver
Police Department.
The quick buildup system shall provide sufficient air pressure so that the apparatus has no brake drag and is able to stop
under the intended operating conditions following the 60-second buildup time.
ROAD EMERGENCY SAFETY KIT
One (1) set of three (3) dual faced triangular warning flares with fold away base complete with storage case per DOT
requirements shall be provided with the completed apparatus.
One (1) 2.5 lb. ABC type vehicle fire extinguisher with bracket per DOT requirements shall be provided with the completed
apparatus.
AUTOMATIC VEHICLE LEVELING SYSTEM
An HWH brand leveling system shall be installed on the unit designed for large heavy duty vehicles with a GVWR over
23,000 pounds. The system shall have four (4) mounting brackets bolted to the chassis frame rails, two (2) front and two
(2) rear. Each jack shall bolt to the bracket attached to the chassis frame.
The system shall have a drive-off safety feature. If the vehicle ignition switch is on and any legs are not fully retracted, a
warning alarm shall sound.
The system shall be provided with a one (1) year limited warranty.