Specifications

Vancouver Police Service
Command
Production Specification
SVI #847 Page 33 of 107 September 18, 2012
ACCIDENT PREVENTION
There shall be a placard in the cab seating area which reads, "ALL OCCUPANTS MUST BE SEATED AND BELTED
WHEN THE APPARATUS IS IN MOTION".
PERSONNEL CAPACITY
A label that states the number of personnel the vehicle is designed to carry shall be located in an area visible to the driver.
ACCIDENT PREVENTION
If the rear bumper is 8" deep or more, there shall be a placard on the rear face of the body, in clear sight from the ground,
which reads, "WARNING - DO NOT RIDE ON STEPS OR DECK AREAS WHILE THE APPARATUS IS IN MOTION.
DEATH OR SERIOUS INJURY MAY RESULT".
WEARING HELMET WARNING
A label stating “DO NOT WEAR HELMET WHILE SEATED” shall be visible from each seating location.
FRONT BUMPER
The front bumper shall be as provided by the cab/chassis manufacturer. No other alteration or modifications are required.
FRONT TOW PROVISIONS
The front tow provisions shall be supplied and installed by the cab/chassis manufacturer.
EXHAUST
The exhaust system shall be as provided by cab/chassis manufacturer. The tailpipe may require some modifications for
proper ground clearances and fit with body.
The exhaust piping and discharge outlet shall be located or shielded so as not to expose any portion of the vehicle or
equipment to excessive heating.
Exhaust pipe discharge shall be directed away from any operator’s position or entry doors on body.
Where parts of the exhaust system are exposed so that they are likely to cause injury to operating personnel, protective
guards shall be provided.
RADIO/ANTENNA INSTALLATION
There shall be one (1) Vancouver Police Department supplied Harris M7300 radio(s) with antenna installed in the cab
console.
Radio shall be installed per Manufacturer's requirements and wired for proper 12 volt power and ground.
CAB DOME LIGHT OVERRIDE SWITCH
There shall be a switch provided in the multiplex display to allow the cab dome light to be disabled from actuating with the
door opening.