Specifications

Vancouver Police Service
Command
Production Specification
SVI #847 Page 103 of 107 September 18, 2012
Wi-Fi NETWORK – EXTERNAL/INTERNAL ACCESS POINT
There shall be one (1) one (1) Cisco AIR-CAP1552E-A-K9 external access point and recommended three (3) antennas to
provide wi-fi network access to the exterior of the vehicle.
The External Access Point system shall:
• Use Cisco certified antennas
• Have antennas placed to maximize access around the vehicle perimeter
• Have antennas wired to the external access point with loss on cabling calculated to comply with Industry Canada
regulations
• Be wired to the integrated services router (Cisco NMEAIR-WLC6-K9 wireless controller will be installed in integrated
services router by VPD)
Wi-Fi NETWORK – INTERNAL ACCESS POINT
There shall be one (1) one (1) Cisco AIR-CAP3502I-X-K9 internal access point and recommended antenna to provide wi-
fi network access to the exterior of the vehicle.
The Internal Access Point system shall:
• Be mounted placed to maximize access in the vehicle interior. Roof mounting preferred.
• Be wired to the integrated services router (Cisco NMEAIR-WLC6-K9 wireless controller will be installed in integrated
services router by VPD)
CELLULAR ANTENNA
There shall be one (1) cellular network antenna provided and installed for access to the Rogers cellular network and Cisco
for Roger’s LTE network (with 3G backward compatibility). The antenna shall be mounted to allow for best access and
connected to the integrated services router.
One (1) Vancouver Police Department supplied Cellular LTE HWIC shall be supplied and installed in integrated services
router.
FLAT PANEL MONITOR(S)
One (1) Commercial grade, 30” multiple input, flat panel LCD monitor(s) shall be provided in outside curbside video
compartment. System shall be complete and fully operational, including all miscellaneous coax cable, 120 volt AC wiring,
and cable connections.
The monitor installation shall include an additional two (2) shielded CAT6 inlet/outlets.
COLOR MULTIFUNCTION PRINTER
There shall be one (1) Vancouver Police Department supplied Xerox 8860MFP (or equivalent) multi-function printer in the
Command Room. The exact printer location shall be determined at the pre-build meeting.
The following shall be provided with the printer installation:
• Two (2) circuit labeled RJ-45 plugs with shielded CAT6 cabling that terminates at the rack mount patch panel with 12’
of slack per cable. A cable certification report confirming that all network wiring complies with CAT6 specifications to
be included.
• One (1) 120 VAC, 20 amp, duplex straight blade receptacle (NEMA 5-20R) circuit labeled outlet.