Specifications

Example: Store 555-1234, plus tone number 765-4321 in memory
location 18:
a. Press MEMO
b. Press
5551234
c. Press
RDL/P (To enter delay between numbers)
d. Press /
TONE (Switches to Tone Mode; counts as one digit.)
e. Press
7654321 (Number entered in Tone Mode)
f. Press
MEMO
g. Press
18 . Base Unit beeps confirmation and the TALK LED goes out.
Erasing a Stored Number
1. On the Base Unit, press
MEMO twice .
2. Press the memory location number or the
ONE-TOUCH DIALING button you
want to clear. You will hear a long beep confirming the number is erased.
Using your EXP 9200 Intercom
Note: The RING ON/BATT SAVE switch on the Handset must be in the
“
RING ON”position. The Base Unit RINGER/VOLUME switch must be set to
either “
LO ” or “ HI .” (Note: When a call is ON HOLD at the Handset
and the Base Unit is paged, the Base Unit will ring even when the
RINGER/VOLUME switch is set to “ OFF . ” )
Paging from the Base Unit to the Handset
1. Press
INT’COM . (If no answer, press INT’COM again to disconnect.)
2. Press
TALK or INT’COM on the Handset to answer the page. Speak into the
mouthpiece.
3. To turn off the Intercom, press
SP. PHONE on the Base Unit.
— OR —
Press
TALK on the Handset.
Paging from the Handset to the Base Unit
1. Press
INT’COM on the Handset. (If no answer, press INT’COM to disconnect.)
2. At the Base Unit, press
SP. PHONE or INT’COM to answer the page. Speak
into the microphone.
3. To turn off the Intercom, press
SP. PHONE at the Base Unit.
—OR—
Press
INT’COM on the Handset.
✱
21