Specifications
Table Of Contents
- CONTENTS
- Illustrations (Base Unit Controls and Functions)
- Illustrations (Handset Controls and Functions)
- Important Safety Instructions
- About Your EXP 9100 4
- EXP 9100 Features 5
- Installing Your EXP 9100 7
- Using your EXP 9100
- Preparing the Base Unit and Handset 14
- During a Call 14
- Handset Earpiece Volume 14
- Mute Mode 14
- Out of Range Indicator 14
- Keypad Lights 14
- Answering a Call 15
- Making a Call 15
- Dialing a Stored Number 15
- Chain Dialing 16
- Special Features 16
- Placing a Call On Hold 16
- Monitoring a Call 16
- Using the Flash/R. Tone Button 16
- Last Number Redial
- Using Your EXP 9100 Memory 17
- Storing a Number 17
- Storing a One-Touch Dialing Number 17
- Storing Mixed Tone/Pulse Numbers 18
- Erasing a Stored Number 18
- Using your EXP 9100 Intercom 18
- Paging from the Base Unit 19
- Paging the Base Unit While a Call is Holding 19
- Paging from the Handset to the Base Unit 19
- Using the EXP 9100 as a Room Monitor 19
- Troubleshooting 20
- Specifications 22
- Cover
- Precautions
- One-Year Limited Warranty
- Back Cover
Installing the Base Unit on a Desk or Tabletop
NOTE: Refer to the foldout located in the back of this Operating Guide to
help familiarize you with the controls of your cordless phone.
1. Place the Base Unit on
a desk or tabletop, and
plug one end of the
Telephone Line Cord
(supplied) into the
“
LINE IN
” jack on the
Base.
2. Plug the other end of
the Telephone Line
Cord into the telephone
wall jack.
3. Plug the AC Adapter
cord into the AC
Adapter input jack on
the Base Unit.
(
Note:
Use only the AC Adapter supplied with the
EXP 9100
.
)
4. Plug the AC Adapter into a standard 120V AC wall outlet.
5. Route the power cord where it will not create a trip hazard, or where it
could become chafed and create a fire or other electrical hazards.
The unique design of your
EXP 9100
allows you to place the Handset on the
Base Unit either face down or in an upright position. Also, you may extend the
legs on the bottom of the Base Unit, placing it at an angle for better visibility of
the LEDs (See the Base Unit Fold-out illustration). Remove the Handset
Support in the charging cradle so the handset remains in a stable, upright
position. The Battery Pack in the Handset automatically recharges in either
position.
8