Specifications
Table Of Contents
- CONTENTS
- Illustrations (Base Unit Controls and Functions)
- Illustrations (Handset Controls and Functions)
- Important Safety Instructions
- About Your EXP 9100 4
- EXP 9100 Features 5
- Installing Your EXP 9100 7
- Using your EXP 9100
- Preparing the Base Unit and Handset 14
- During a Call 14
- Handset Earpiece Volume 14
- Mute Mode 14
- Out of Range Indicator 14
- Keypad Lights 14
- Answering a Call 15
- Making a Call 15
- Dialing a Stored Number 15
- Chain Dialing 16
- Special Features 16
- Placing a Call On Hold 16
- Monitoring a Call 16
- Using the Flash/R. Tone Button 16
- Last Number Redial
- Using Your EXP 9100 Memory 17
- Storing a Number 17
- Storing a One-Touch Dialing Number 17
- Storing Mixed Tone/Pulse Numbers 18
- Erasing a Stored Number 18
- Using your EXP 9100 Intercom 18
- Paging from the Base Unit 19
- Paging the Base Unit While a Call is Holding 19
- Paging from the Handset to the Base Unit 19
- Using the EXP 9100 as a Room Monitor 19
- Troubleshooting 20
- Specifications 22
- Cover
- Precautions
- One-Year Limited Warranty
- Back Cover
EXP 9100 Features
Spread Spectrum Technology
UltraClear Plus
noise reduction provides the quality sound
of a corded telephone.
Auto Power Control
Tone/Pulse Dialing
20-Number Memory
Maximum Operating Range
3 One-Touch Memory Dialing Buttons
Room Monitoring
2-Way Paging/Intercom
Redial/Pause and Flash
Spare Battery Charger/Battery Back-Up
AutoStandby
AutoTalk
Auto Channel Scan
Auto Channel Change
Automatic Digital Code Security
Handset Volume Control/Ringer Volume Control
Base Unit Ringer Volume Control
Battery Saving Feature
2-Way Handset Mounting
Reversible Handset Retainer
Mute
Hold
Lighted Keypad
Automatic Digital Code Security
Many cordless telephones operate similarly and on the same frequency.
Without digital code security, another Handset could make calls using your
Base Unit and telephone line. Therefore, to avoid any unauthorized calls
through your Base Unit, a Digital Code feature was added to your
EXP 9100
.
This Digital Code is shared only between the Handset and Base Unit. The
Code is set
automatically
when you first use the phone.
To reset the Digital Code:
1. Be sure the Handset is on the Base Unit.
2. Press
INT’COM
on the Base Unit. The Base Unit and Handset will begin
beeping.
3. Remove the Handset from the Base Unit and set it down again. The
Base Unit and Handset will stop beeping.
The Digital Code is now reset randomly to one of more than 65,000 codes.
5