Specifications

Storing Mixed Tone/Pulse numbers:
If your Base Unit is set up for Pulse Dialing, you can store a mixed mode
number (up to 16 digits) to easily access long distance services or other
services requiring Tone inputs.
1. Follow steps 1 and 2 in “Storing a Number,” then:
2. Enter the number to be dialed in Pulse Mode.
3. Press the
TONE button on the Handset
(NOTE:
The TONE button counts as one digit. )
4. Enter the number to be dialed in Tone Mode.If desired, press
RDL/P to
enter delays between numbers.
5. Follow steps 4 and 5 in “Storing a Number.”
Example: Store 555-1234, plus tone number 765-4321 in memory
location 18:
a. Press MEMO
b. Press
5551234
c. Press
RDL/P (To enter delay between numbers)
d. Press
TONE (Switches Handset to Tone Mode; counts as one digit)
e. Press
7654321 (Number entered in Tone Mode)
f. Press
MEMO
g. Press
18
Handset beeps confirmation and the TALK LED goes out.
Erasing a Stored Number
1. Remove the Handset from the Base Unit.
2Press
MEMO twice .
3. Press the memory location number or the
ONE-TOUCH DIALING button you
want to clear. You will hear a long beep confirming that you have
erased the number.
Using your EXP 9100 Intercom
NOTE: The RING ON/BATT SAVE switch on the Handset must be in the
“
RING ON ” position.
The Base Unit
RINGER/VOLUME switch must be set to either
“
LO ” or “ HI ”.
Paging from the Base Unit
1. Press
INT’COM . (If no answer, press INT’COM again to disconnect.)
2. Press
TALK or INT’COM on the Handset to answer the page.
Speak into the mouthpiece.
3. To turn off the Intercom, press
INT’COM on the Base Unit
— OR —
Press
TALK or INT’COM on the Handset.
18