User guide

AirMagnet Spectrum XT User Guide
Chapter 6: Analyzing Spectrum Data 79
•Zigbee Devices
• Non-Bluetooth Wireless Mouse
• Motion Detector
• Radar
Figure 6-15 shows the information contained in the Non-WiFi Devices table.
Figure 6-15: Non-WiFi Devices
The Non-WiFi Devices table shows the following information about each non-WiFi device
that are listed:
• Name (Device Type) - The device category a device belongs to (refer to the bullet list
above).
• Peak Power dBm - The highest energy reading in dBm ever recorded of device.
• Avg Power dBm - The average energy reading in dBm of the device.
• First Seen Time - The time when the device was detected for the first time.
• Last Seen Time - The most recent time when the device was detected.
• Event Count - The number of times the device was detected (refer to the Event
Spectrogram)
• Last Seen Channel - The channel on which the device was last detected.
• Affected Channels - Channels that are affected by the device.
• Center Frequency GHz - The center frequency used by the device.
• Duty Cycle - The percentage of time that the RF energy is present in the channel
above the noise floor.
• Is Active - Indicates if the device is active or not. You’ll see a check mark if it is active,
or a cross mark if otherwise.
• Is Hopping - Indicates if the device is a frequency-hopping device. You’ll see a check
mark if it is a frequency-hopping device, or a cross mark if it is otherwise.