User guide

34 Chapter 4: Menus and Tools
AirMagnet Spectrum XT User Guide
To set or change the display of WiFi or spectrum data:
1) From the toolbar, click Settings>Configure...The default Configure dialog box
appears.
Figure 4-4: Configuring General settings
2) Make the selections as described in Table 4-3.
3) Click Apply and then OK when done.
Table 4-2: Configuring AirMagnet Spectrum XT’s General Settings
Parameter Description
WiFi Devices These parameters apply to WiFi devices only.
Show device name If selected, the names of WiFi devices will show on the screen
wherever applicable.
Show with vendor name If selected, vendor names will show as part of devices names on the
screen.
Show MAC address always If selected, MAC addresses will always appear as part of device
identification.