User guide

86 Chapter 6: Analyzing Spectrum Data
AirMagnet Spectrum XT User Guide
Configuring the Interference Power vs Time Graph
As mentioned above, the configuration menu for the Interference Power vs Time graph allows
the user to alternate between displaying interference data by channel and by device type.
Refer to Table 6-8 for specific options that can be configured in the graph, as shown below.
Figure 6-23: Interference Power vs Time Configuration
Table 6-8: Interference Power vs Time Graph Parameters
Parameter Description
Trend Type Select whether to display data by channel or by device as desired.
Trend Options Depending on the selection made in the Trend Type field, these fields allow the
user to select the channels or devices that should be displayed.
Show First/
Second/Third
Trace
These fields activate or deactivate the trace options specified in the first portion
of the configuration. Select ‘Yes’ to activate (e.g., display) each trace as needed.
Selecting ‘No’ will remove the trace from the graph.
Maximum
Power
Allows the user to specify the maximum power to be displayed in the graph.
Highlight the existing value and then override it with a new value.
Minimum Power Allows the user to specify the minimum power to be displayed in the graph.
Highlight the existing value and then override it with a new value.
Time Interval
(Secs)
The maximum number of seconds that will be displayed on the chart at any
given time.