Owner's Manual

EXP1240 System Installation Guide Revision 06

7) If you want the base station to log low level multi cell debug information in the System

Log, set the Multi cell debug field to Data Sync, Auto Tree, or Both. (This log contains a

large number of messages, so you should leave it disabled most of the time.)

8) Click Save, then reboot the base station (go back to the Home/Status screen and click

Reboot).

9) When the base station finishes rebooting, verify that the RFPI-Address on the

Home/status screen shows RPN:00 at the end of the field. After a few minutes, the System

Information field also updates to display the new status.

Figure 23:

Home/status

screen (primary base enabled)

Configuring Level 1 Base Stations

1) Place the first Level 1 base station at its final location.

2) Login to the base station.

3) Reset the base station to its default settings (open the Management screen and click

Default Base Station). If this base station has never been configured, skip this step.

4) Go to the Multi-cell screen and set the Multi cell system field to Enable.

5) Enter the System chain ID of the chain this base station should belong to.

6) If you want the base station to include low level multi cell debug information in the

System Log, set the Multi cell debug field to Data Sync, Auto Tree, or Both. (This log

contains a large number of messages, so you should leave it disabled most of the time.)

7) Click Save and reboot the base station (go back to the Home/Status screen and click

Reboot).

8) When the base station finishes rebooting, click Home, and after a few minutes, go back

to the Multi-cell screen. You will see that the System chain ID field is read-only, and the

DECT system settings and Base station settings fields, and the Base Station Group table are

added to the bottom of the screen.