Owner's Manual

EXP1240 Admin Guide, Version 2.0
Proprietary and Confidential
Chapter: Firmware Upgrade Procedure
90
After entering required version choose Start update button > select OK button from the dialog window to
start the update/downgrade procedure.
The relevant base station(s) will automatically reboot and retrieve the firmware specified from the server
and update itself accordingly.
The base firmware update behaviour is: Base will fetch the fwu file for approximately 3 minutes, then
reboot and start flashing the LED - indicated by LED fast flashing for approximately 3 minutes and reboots
in new version.
Note: All on-going voice calls are dropped from the base station(s) immediately the firmware update
procedure starts.
8.5.1 Base firmware confirmation
Base station firmware version status in a multicell environment can be seen in the multicell base station
group overview page, column 4.
8.5.2 Verification of Firmware Upgrade
Syslog information when Management Syslog level is set to “Debug”
[ FWU Downloading File tftp://10.1.24.101/FwuPath/Beatus/BeatusSw_4181_v0202.fwu]
[ Base FWU started]
[ Base FWU ended with exit code 2101 (NE_FILE_TRANSFER_EOF): End of file]