Owner's Manual

EXP1240 Admin Guide, Version 2.0
Proprietary and Confidential
Chapter: Multi-cell Setup & Management
76
6.4.3 Case ##3: Large to Medium Sized Enterprises
In this scenario, we have five slave bases synchronised to one master base. The master base is located in
office block B while the slave bases are spread across the whole enterprise. No base station is deployed in
the lift because it has high attenuation properties that will drastically reduce radio signals.
The procedure:
STEP 1 Follow the steps described in sections 0
STEP 2 On the Network page of each base define the DECT sync source settings as illustrated in the
table below.
STEP 3 Save and reboot each base to complete case ## 3 setup
Multi Cell Page of Base Stations
Recommended settings of MAC-units in Chain section of page (Other valid setting exists):
NOTE:
The number of chains cannot exceed 12 levels.
RPN Ver MAC Addr IP Addr IP Status
DECT sync
source
DECT
Property
00
XX XX:XX:XX… XXX.XXX… Connected 1: RPN:04
04
XX XX:XX:XX… XXX.XXX… Connected 2: RPN:08
08
XX XX:XX:XX… XXX.XXX… Connected 3: RPN:0C
0C
XX XX:XX:XX… XXX.XXX… Connected 4: RPN:10
10
XX XX:XX:XX… XXX.XXX… Connected 4: RPN:10 Primary
14
XX XX:XX:XX… XXX.XXX… Connected 4: RPN:10