Owner's Manual

EXP1240 Admin Guide, Version 2.0
Proprietary and Confidential
Chapter: EXP1240 Administration Interface
55
Parameter
Default Values
Description
Number
of SIP
accounts
before
distributed
load
8
The maximum number of handsets or SIP end nodes that are permitted
to perform location registration on a specific Base unit before load is
distributed to other base units.
Note: A maximum of 8 simultaneous calls can be routed through each
Base unit in a multi-cell setup.
Permitted Input: Positive Integers (e.g. 6)
SIP
Server
support for
multiple
registrations
per account
Disabled
Enable this option so it is possible to use same extension (i.e. SIP
Account) on multiple phones (SIP end nodes). These phones will ring
simultaneously for all incoming calls. When a phone (from a SIP
account group) initiates a handover from Base X to Base Y, this phone
will de-register from Base X, and register to Base Y after a call.
Note: Choose Yes when the SIP server supports this feature otherwise
choose No for the Sip server does not support this feature.
Permitted Input: Yes, No
5.12.4 Base Station Group
The Base station group list various parameter settings for base stations including chain level information.
Screenshot:
Parameters
Description
ID
Base unit identity in the chained network.
Permitted Output: Positive Integers
RPN
The Radio Fixed Part
Number
is an 8
-
bit DECT cell identity allocated by the
installer. The allocated RPN within the EXP1240 must be geographically unique.
Permitted Output: 0 to 255 (DEC) OR 0x00 to 0xFF (HEX)
Version
Base station current firmware version.
Permitted Output: positive Integers with dot (e.g. 273.1)
MAC Address
Contains the hardware Ethernet MAC ad
dress of the base station. It varies from
Base station to Base stations.
IP Status
Current Base station behaviour in the
EXP1240
network.
Possible Outputs