Owner's Manual

EXP1240 Admin Guide, Version 2.0
Proprietary and Confidential
Chapter: EXP1240 Administration Interface
54
5.12.2 DECT System Settings
Description of DECT Settings for Specific Base units is as follows:
Screenshot
Parameter
Default values
Description
DECT system
RFPI
Not able
This is a radio network identity accessed by all
Base units in a specific
multi-cell system. It composed of 5 octets. It is actually 5 different
variables combined together.
RFPI Format: XX XX XX XX XX (where XX are HEX values)
Allow multi
primary:
Disabled
This feature is used for multi
-
location setups
. Allows two or more
primary in the same system.
The two cells will be unsynchronized and handover will not be possible.
Auto create
multi
primary:
Disabled
By enabled the system can generate cells in case a base goes into faulty
mode. Two cells will only be generated in case no radio connection
between the two cells is present. In order to recover the full system after
establish of the faulty base, the system must be rebooted.
Allow multi primary must be enabled for this feature to also be enabled.
Auto
configure
DECT sync
source tree
Enabled
Enable this to allow the
system
to automatically synchronise the multi
-
cell chain/tree.
NOTE: Must be enabled in order to allow a new primary recover in case
the original primary goes into faulty mode.
Allow multi primary must be enabled for this feature to also be enabled.
Note: To run with a system with two separate primary in two locations “Allow multi primary” and “Auto
configure DECT sync source tree” must be enabled. To add the second primary the slave must manually be
configured as primary. Alternatively the “Auto create multi primary” must be enabled.
5.12.3 Base System Settings
Description of SIP Settings for Specific Base units is as follows:
Screenshot